Dovetail Splines

This morning I had a bit of time in the shop after some of the usual homeowner fare.  So I built this extremely visually engaging jig.

Not so much – but it works well at cutting dovetails slots across mitered corners.


Using the same dovetail bit, I can then make a spline piece to fill into these slots.   The case is red oak. The splines are walnut.


The two dovetail splines are towards the back of the case. I straight spine will go towards the front, and the door piece will be cut away.
When these are dry I can finish cutting away the spline and sand it flush.



One Comment on “Dovetail Splines”

  1. […] Dovetail splines. Straight splines. Door / glass. […]

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s